Message by __Juan Pablo Gonzalez __:
hi,
When simulation is running appear folowing message:
WARNING: Newton did not reach convergence.
What is wrong? how do i solve this problem?
regards
Message by Nuno Loureiro:
Hi,
I believe this means that you should allow more iterations to the Newton method when solving the non-linear Poisson equation. You can do this by increasing the value of the iterNewton parameter in the “Poisson Equation” tab in GlobalParameters. Check if that works.
regards,
Nuno
Message by __Juan Pablo Gonzalez __:
Nuno,
I change iterNewton from 50 to 200, but it doesn’t works.
I’ll try with higher values.
Thanks, Juan Pablo
Message by __Juan Pablo Gonzalez __:
I tried higher values, but it doesn’t work, Newton did not reach convergence.
I dont know what happend.
Regards
Juan pablo
Message by Nuno Loureiro:
hello,
I’m sorry I thought that would work.
You have an old post with the same topic: https://forum2.spis.org/t/archive-79425723c0a8001401f97e0e5946fcdb
You can try to do the same
Regards,
Nuno