# \[Archive\] Erosion

**URL:** <https://forum.spis.org/t/archive-erosion/803>\
**Category:** SPIS\
**Created:** [3 September 2020 09:54 UTC](https://forum.spis.org/t/archive-erosion/803 "2020-09-03T09:54:00Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![system](https://forum.spis.org/uploads/default/original/1X/887f7e402a70666bad1816db2c64fefd698b4b0f.png) [@system](https://forum.spis.org/u/system)\
**Post date:** [3 September 2020 09:54 UTC](https://forum.spis.org/t/archive-erosion/803/1 "2020-09-03T09:54:00Z")

</div>

Message by **Tanguy Krzymuski** :  
Hello,  
I’m currently trying to simulate erosion on spacecraft surfaces using SPIS 6.0.4  
I can successfully run simulations but the values of “improved emitted flux of Eroded …” vary a lot from a mesh cell to another one that is very close.  
The results I get for “improved collected flux of …” are however quite smooth.  
How to smooth the results for erosion?  
I’ve tried to increase particles densification as well as mesh refinement.  
Has anyone been facing the same problem?  
Best regards  
Tanguy

---

<div class="post-metadata">

**Author:** ![system](https://forum.spis.org/uploads/default/original/1X/887f7e402a70666bad1816db2c64fefd698b4b0f.png) [@system](https://forum.spis.org/u/system)\
**Post date:** [3 September 2020 15:02 UTC](https://forum.spis.org/t/archive-erosion/803/2 "2020-09-03T15:02:50Z")

</div>

Closed on 3 September 2020 15:02 UTC


